Moisture risk of spray foam insulation applied to timber sloped roofs
An investigation of moisture risk when spray foam insulation is applied to timber sloped roofs with different resistance underlays.
Applies to England
Documents
Details
This modelling investigates the level of moisture and timber degradation risk which may be encountered when a sprayed foam insulant is applied to typical domestic timber roofs.
The modelling indicates that risks are low when an open cell (moisture permeable) insulant is applied in line with guidance described in British Standard BS 5250:2021.
Levels of theoretical risk vary with the temperature conditions when the insulant is applied directly to a low resistance underlay. Low levels of risk were found in a climate considered typical for London for all scenarios. Medium levels of risk were found in a climate considered typical for Newcastle for most scenarios.
The modelling identified higher levels of risk in some scenarios when a sprayed foam is applied to high resistance underlay. In particular, high risks were determined in London when open cell insulation is applied with no Air and Vapour Control Layer (AVCL) present, reducing to low risks when a closed cell insulant and/or an AVCL is used. High levels of risk were also identified in Newcastle, which were reduced to a medium or low risk by the presence of an AVCL.
The highest risk assessed is when spray foam insulation is applied directly onto the roof covering. This leads to high risks under all modelled scenarios.