Closed loop ground source heating and cooling systems: when you need a permit
Check if you need an environmental permit for a closed loop ground source heating and cooling system.
Applies to England
Overview
You may need to get a permit from the Environment Agency before you can install and run a new closed loop ground source heating and cooling system. This is a system that:
- is fully sealed
- does not take water from the environment
- does not discharge water or fluids to the environment
Boreholes or pipework used for these systems are fully sealed and have no direct connection with any groundwater.
The Environment Agency regulates these systems to protect the environment.
Existing systems installed before 2 October 2023
If your ground source heating and cooling system was installed before 2 October 2023, it is an ‘existing’ system.
If so, you do not need to meet the exemption conditions or have an environmental permit to run the system. But the system must not cause pollution.
New systems installed on or after 2 October 2023
If your ground source heating and cooling system is installed on or after 2 October 2023, it is a ‘new’ system.
If you’re looking to install and run a new system, you must do one of the following:
- meet all the criteria in the exemption conditions for systems in low environmental risk settings
- meet all the conditions in the regulatory position statement ‘Discharge of heat to ground from a single closed loop ground source heating and cooling system supplying residential premises: RPS 307’
- get a standard rules permit
- get a bespoke permit
Exemptions for new systems in low environmental risk settings
If you meet all the exemption conditions, you do not need a permit for a new closed loop ground source heating and cooling system.
Check the guidance on the exemption conditions and how to meet them.
RPS 307
If your system does not meet all the exemption conditions, check if you can meet all the conditions in the regulatory position statement ‘Discharge of heat to ground from a single closed loop ground source heating and cooling system supplying residential premises: RPS 307’.
If your system cannot meet either the exemption conditions or the conditions in RPS 307, you will need to apply for an environmental permit.
Standard rules permits for new systems
Standard rules permits are suitable for activities where:
- the general risks are well understood and reduced
- a site specific risk assessment is not necessary because of this
The Environment Agency will soon consult on a standard rules permit for closed loop ground source heating and cooling systems. They aim to make this option available after the response to the consultation.
Bespoke permits for new systems
You must apply for a bespoke permit if your new closed loop ground source heating and cooling system:
- cannot meet all the conditions in the exemption criteria
- cannot meet all the conditions in RPS 307
- cannot meet the conditions in a standard rules permit, when they are available
To apply for a new, bespoke groundwater activity permit for a closed loop ground source heating and cooling system, fill in the Part B6 form.
You must also fill in part:
You will need to use an Adobe Acrobat product to complete the forms.
Contact the Environment Agency
General enquiries
National Customer Contact Centre
PO Box 544
Rotherham
S60 1BY
Email [email protected]
Telephone 03708 506 506
Telephone from outside the UK (Monday to Friday, 8am to 6pm GMT) +44 (0) 114 282 5312
Monday to Friday, 8am to 6pm.
Updates to this page
Published 2 October 2023Last updated 30 September 2024 + show all updates
-
Added information about the regulatory position statement ‘Discharge of heat to ground from a single closed loop ground source heating and cooling system supplying residential premises: RPS 307’.
-
First published.